Jul 6 15:34:02 localhost kernel: usb 1-2.4: new full speed USB device using uhci_hcd and address 29 You should see messages similar to the following: Verify after inserting the U10/U20 that the USB hot-plug support is working by looking at /var/log/messages. The first time that you use this software, you will want to continue with the following steps to verify that the software and hardware are working correctly.Insert the U10/U20 USB Network Interface into an available USB port.The installation can be checked at any time using the dhchk script that is installed by the RPM you installed in step 2.This RPM includes the headers needed to develop OpenLDV applications. If you will be developing OpenLDV applications on this box, double-click.If that is the case, install libusb-0.1., then, then. If libftdi will not install, it is normally because libusb is also not included in your kernel. If that is the case, install and then try installing again. If it is the case that your kernel does not include libftdi, you will get an error message instead. The U10/U20 network interface driver will install.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |